Original Meanwell LPV-100-12 Constant Voltage - M16

Power Supply LPV-100-12 12V Mean Well lP67 - M16

Rp 365.000 Rp 320.000

Berat: 700,00 kg

Availability: In Stock

Deskripsi

Constant voltage mode power supply
Universal AC input / Full range

Withstand 300VAC surge input for 5 seconds
Protections: Short circuit / Over current / Over voltage

Cooling by free air convection

Fully encapsulated with IP67 level (Note.8)

Fully isolated plastic case

Suitable for LED lighting and moving sign applications

100% full load burn-in test

Low cost, high reliability
2 years warranty

Specification

MODEL		LPV-100-12
OUTPUT	DC VOLTAGE	12V
	CURRENT RANGE	0 ~ 8.5A
	RATED CURRENT	8.5A
	RATED POWER	102W
	RIPPLE & NOISE (max.) Note.2	120mVp-p
	VOLTAGE TOLERANCE Note.3	±5.00%
	LINE REGULATION	±1.00%
	LOAD REGULATION	±2.00%
	SETUP, RISE TIME NOTE.6	2000ms, 25ms / 230VAC 2000ms, 25ms / 115VAC at full load
	HOLD UP TIME (Typ.)	50ms/230VAC 14ms/115VAC at full load
INPUT	VOLTAGE RANGE	90 ~ 264VAC 127 ~ 370VDC
	FREQUENCY RANGE	47 ~ 63Hz
	EFFICIENCY (Typ.)	85%
	AC CURRENT (Typ.)	2.2A/115VAC 1.2A/230VAC
	INRUSH CURRENT (Typ.)	COLD START 75A/230VAC
	LEAKAGE CURRENT	0.25mA / 240VAC
PROTECTION	OVER CURRENT	110 ~ 150% rated output power
	OVER CURRENT	Protection type : Hiccup mode, recovers automatically after fault condition is removed
	OVER VOLTAGE	13.8 ~ 16.2V
	OVER VOLTAGE	Protection type : Shut down O/P Voltage,re-power on to recover
ENVIRONMENT	WORKING TEMP.	-25 ~ + 70°C (Refer to output load derating curve)
	WORKING HUMIDITY	20 ~ 90% RH non-condensing
	STORAGE TEMP., HUMIDITY	-40 ~ +80°C , 10 ~ 95% RH
	TEMP. COEFFICIENT	± 0.03%/°C (0 ~ 50°C )
	VIBRATION	10 ~ 500Hz, 2G 12min./1cycle, period for? 60min. each along X, Y, Z axes
SAFETY &EMC(Note 4)	SAFETY STANDARDS	IP67 approved;design refer to TUV EN60950-1
	WITHSTAND VOLTAGE?	I/P-O/P:3KVAC
	ISOLATION RESISTANCE	I/P-O/P:>100M Ohms /500VDC/ 25°C/70% RH
	EMI CONDUCTION & RADIATION	Compliance to EN55022 (CISPR22) Class B
	HARMONIC CURRENT	Compliance to EN61000-3-2 Class A,EN61000-3-3
	EMS	Compliance to EN61000-4-2,3,4,5,6,8,11; ENV50204, EN55024, light industry level, criteria A
	IMMUNITY
OTHERS	MTBF	703Khrs min. MIL-HDBK-217F (25 )
	DIMENSION	1905237mm (LWH)
	PACKING	0.63Kg; 20pcs/13.6Kg/0.51CUFT
NOTE	1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature.
	2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
	3. Tolerance : includes set up tolerance, line regulation and load regulation.
	4. Derating may be needed under low input voltage. Please check the static characteristics for more details.
	5. The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.
	6. Length of set up time is measured at first cold start. Turning ON/OFF the power supply may lead to increase of the set up time. 7.The unit might not be suitable for lighting applications in EU countries. Please check with your local authorities for the plssible use of the unit. 8.Suitable for indoor use or outdoor use without direct sunlight exposure,Please avoid immerse in the water over 30 minute.

Top